Skip to content
  • There are no suggestions because the search field is empty.

How long does a Pulsoid chip last?

Pulsoid chips are precision consumables, and how long each one lasts depends on how it is used. Sample type, sample preparation and handling all affect a chip's working life, so it varies from one experiment to the next.

For best results, use a new Pulsoid chipeach session. Reuse may be possible in some cases; see How should I store Pulsoid chips? for guidance. During your session, we recommend checking chip performance with calibration particles.

What affects chip life

  • Samples containing large aggregates or particles can block the pore.
  • Well-prepared samples help keep measurement conditions stable for longer.
  • Repeated unblocking and cleaning can affect chip performance over time.

Signs it's time to replace your chip

  • Sudden jump in current: The current (nA) rises suddenly at the same voltage. This can mean the pore has ruptured.
  • Frequent pore blocking: The chip blocks more often than when it was first used. A blockage usually shows as a sudden drop in baseline current, more baseline noise (RMS) and a sharp fall in particle rate.
  • Particles don't pass through: The baseline stays noisy and no particle blockades are detected.
  • No stable baseline: A stable baseline can’t be achieved, even after several troubleshooting steps.

How to get the most from your chip

  • Choose the right chip. Use the largest chip suitable for your sample. We recommend the P5T unless you need to measure particles below 45 nm, as it covers the widest range and is less prone to blocking. See Which Pulsoid chip should I use?
  • If your sample contains large aggregates, pass it through a 0.1 µm filter or centrifuge it to remove larger particles. Note that filtering may change the composition of your sample.
  • Make sure your sample is compatible with the measurement electrolyte (ME).

Use the NPS Reagent Kit to prepare contaminant-free measurement electrolyte (ME). It is available from the Izon Store.

 

 Tip: Keep spare chips on hand so your measurements stay on track. 

 

Related articles: